Nlynx GEMINI EXPRESS MULTIPLEXER Manuel d'utilisateur Page 1

GEMINI EXPRESS MULTIPLEXERUser’s GuideDocument # 400-2601-01Rev. COctober, 2002

MODE DESCRIPTIONMODE DESCRIPTIONA “POINT TO POINT” link is comprised of two Multiplexer s connected by asingle backbone. A diagram of a “POINT TO POI

Typical Remote Controller Installation(WSC) and the older WSCs is the number of polling groups. The older WSCs hadone polling group for all eight por

CONNECTIONSCONNECTIONSTypical AS/400 InstallationAS/400 TWINAX Brick DetailA major difference between the newer AS/400 work station controllersGXMAS/4

TABLE OF CONTENTSTABLE OF CONTENTSSAFETY 3 Federal Communications Commission (FCC) Statement 3 Classification of LED Transmitter Device 4INTRODUCTIO

Active data pins Configurable per customer requirementOptical SpecificationsFiber optic budget (point topoint)Fiber optic budget (ring) 3 unit ring

Classification of LED Transmitter Device Important:The optical transmitter contains an LED system and is classified “CLASS 1 LEDPRODUCT” per EN60825-1

• Verify that the host work station controller’s (WSC) capacity has notbeen exceeded.• Verify that the device is properly terminated. A peripheral

UNPACKINGUNPACKINGRemove the packing material and check for the items below:GEMINI EXPRESS MULTIPLEXERA (100-240 VAC) input external power supply is a

1. The external power supply is mounted on the rear panel of theGEMINI EXPRESS MULTIPLEXER. The AC power cord must befirmly inserted into the exter

DESCRIPTIONDESCRIPTIONThe GEMINI EXPRESS MULTIPLEXER’s indicators and connections aredescribed below.Power LED Amber LED activates when the GEMINI E

INSTALLATIONINSTALLATIONHost side Multiplexer installation.1. Set the configuration switches on the rear panel of the host sideGEMINI EXPRESS MULTIP